Hermle UWF 902 H, Operating Manual, Page: 98 / 135

4-36
10
13
9
12
11
4.8 NC-Precision Dividing Head
• Press the key "Mod" [5] and select the table of the
user parameters via the softkey [6] .
Now the table of the user parameters will be shown
on the screen.
• Change the parameter MACHINE CODE.
The value which needs to be dialled in, depending
on the options, can be determined by using the
machine code position value table on page 3-23.
• Confirm the value with key "Ent" [7]
Check the oil level indicator whether the oil level is
correct, before starting up the NC dividing head.
Removal of the NC DIVIDING HEAD
Removal of the NC dividing head takes place in
reverse order.
After removal of the dividing head treat all exposed
areas with a rust prevention agent
If you remove the NC dividing head, you must first
cancel the fourth axis to enable the control to
recognize the modified configuration:
• To achieve this, select the programming mode by
pressing key [4], then press key "Mod" [5] and dial
in the key number 95148.
You are now in the table of the machine parameters.
• Change the parameter MP50+MP10 to 7. Confirm
the changed value with key "Ent" [7].
• Press the key "Mod" [5] and select the table of the
user parameters with the softkey [6].
Change the parameter MACHINE CODE. The
value which needs to be dialled in, depending on
the options, can be determined by using the
machine code position value table on page 3-23.
• Confirm the value with key "Ent" [7].
• Plug the bridging plug from the standard equipment
into the 12-pole socket of the rotary encoder [11a].