Hermle UWF 902 H, Operating Manual, Page: 87 / 135

4-25
1
6
5
4
3
7
2
14
15
4.4.3
-
4.4.3 Attachment and Removal of the
NC-Rotary Table
Attachment of the NC-Rotary Table
In order to attach the NC-rotary tabel to the machine
proceed as follows:
• Insert two square (24 x 10 mm) 30 cm long steel
bars [2] approx. 20 cm deep into the central T-
groove.
• Using a suitable lifting device, lift up the NC-rotary
table by the steel bars and carefully transport it to
the machine (see illustration).
• Thoroughly clean the contact faces to remove dirt
and chips, and spray them with a rust prevention
agent.
• Using the electronic handwheel, the cross slide
rest can be precisely positioned against the NC-
rotary table.
• Put the contact surface of the NC-rotary table
against the key ways of the cross slide rest and
fasten with the 6 screws (M 16). A special allen
wrench (14 mm) is part of the standard equipment.
• Switch the main switch of the machine to „0“ [1].
• Remove the covering sheet metal at the top left-
hand side of the cabin by losening of the six
screws.
• Insert the protective tube into the respective
opening.
• Plug the two hydraulic hoses into the connectors
[8]and [9].
• Connect the central lubrication hose to the plug
[10].
• Remove the bridging plug from the socket [12].
• Connect the 12- and 9-pin plugs to the respective
sockets [11] and [12] and secure them by turning
clockwise (90°). Connect the main power plug to
socket [13] and secure it with the safety clip.
• Replace the covering sheet metal.
• Switch on the main switch and start up the machine.
• Via key [4] switch over to the programming mode,
press key „Mod“ [5] and dial in the key number
95148. The table of the machine parameters will
be shown on the screen.
• Change the parameter MP50+MP10 by dialing in
15 for the NC-table or 7 without NC-table.
• The new value needs to be confirmed by pressing
key „Ent“ [7].