Hermle UWF 902 H, Operating Manual, Page: 22 / 135

2-3
8 8 9
2.2 Transport Instructions
2.2 Transport Instructions
HERMLE-Lifting Device
1 Rubber washer
2 Shaft
3 Spacer
4 Splice plate
5 Hexagonal nut
• Ensure that the lifting tackle is of sufficient lifting
capacity.
• Both loops of rope must then be hung onto (or
threaded through) the different lifting devices on
the left and right-hand sides of the machine (see
illustration).
• Unscrew and remove the four holding nuts (24
mm spanner) in the foot of the machine.
• Lift the machine approx 10 cm (4 inches)vertically
upwards with a fork-lift truck or crane and pull the
pallet away from underneath.
• For safety, let the machine down a little and
transport it carefully to the place where it is to be
erected.
Transporting the Machine with a Fork-lift
Truck
When using a fork-lift truck ensure that it is capable
of lifting at least 6000 kg. The fork-lift must be
equipped with a boom at which a cross-beam can
be attached.
6 Rope
7 Lifting device
8 Holding bolts for transport
9 Bottom of packing case, or pallet
 
 

Note
When transporting the machine, the HERMLE lifting
device should normally be used. Under no
circumstances should ropes or lifting tackle be
attached to the following equipment:
• Machine table
• Compound slide
• Spindle slide
ca. 1,65 m