HellermannTyton Autotool CPK hybrid, Operating Instructions Manual

Page: 34 / 47

Operating Instructions • CPK hybrid • 11-2021 • v04 • 106-29004
Troubleshooting
34
DISPLAY MESSAGE POSSIBLE CAUSE SOLUTION
1. Operate bandoleer cutter
2. Open gate
Error, drum
• The cable tie bandoleer is
pulled in at an angle.
• Roller lever drum is jammed
or is defective.
f Push actuator for bandoleer cutter to the left.
f Open the gate.
f
Open the two transparent service flaps at the gate,
à "Troubleshooting a cable-tie bandoleer
malfunction" on page 35 .
;
Error, drum
appears as the next message on the
display.
1. Remove cable-tie residues
2. Press Reset button
Error, drum
f If applicable, carefully remove the cable-tie residues.
f Open the roller lever drum and turn the drum to the
correct position.
f Press the Reset button.
;
Error, gate
appears as the next message on the
display.
f Close the gate.
f Load a new cable tie bandoleer, à "Loading cable
ties" on page 13 .
1. Operate bandoleer cutter
2. Open gate
Overload
• The drum is blocked.
• The bandoleer cutter does
not cut off the cable ties.
• The cable tie bandoleer is
pulled in at an angle.
f Push actuator for bandoleer cutter to the left.
f Open the gate.
f
Open the two service flaps at the gate,
à "Troubleshooting a cable-tie bandoleer
malfunction" on page 35 .
;
Error, overload
appears as the next message on
the display.
1. Remove cable-tie residues
2. Press Reset button
Overload
f
If applicable, carefully remove the cable-tie residues.
f Press the Reset button.
;
Error, gate
appears as the next message on the
display.
f
Close the gate.
1. Operate bandoleer cutter
2. Open gate
Error, tensioning motor
• Drive is jammed or is
defective.
f
Push actuator for bandoleer cutter to the left.
f Open the gate.
f If applicable, carefully remove the cable-tie residues.
f Press the Reset button.
;
Error, gate
appears as the next message on the
display.
f Close the gate.
1. Check binding
2. Confirm with trigger
Error, binding force
• The specified binding force
is not achieved.
The message appears only if
error notification is activated,
à "Check of binding" on
page 17.
f
Check the binding.
f If applicable, reset the binding force.
f If applicable, carefully remove the cable-tie residues.
f Press the trigger as confirmation.