HellermannTyton Autotool CPK hybrid, Operating Instructions Manual

Page: 35 / 47

Operating Instructions • CPK hybrid • 11-2021 • v04 • 106-29004
Troubleshooting
35
DISPLAY MESSAGE POSSIBLE CAUSE SOLUTION
1. Check battery in power pack
2. Press Reset button
Time loss
• The back-up battery for the
clock in the power pack has
discharged.
f Change the back-up battery, à "Changing the battery
of the power pack" on page 36.
f Press the Reset button.
10 .4 Possible fault
FAULT PATTERN POSSIBLE CAUSE SOLUTION
Loops form • Bundle diameter is
unsuitable.
f Use a suitable bundle diameter, à "Positioning and
binding items for bundling" on page 13.
• Tie advancer is not in the
correct position.
f Check the position of the tie advancer,
à
"Checking
tie advancer" on page 38 .
• Spring in upper jaw is faulty. f Check upper jaw flap in upper jaw with spring,
à "Replacing upper jaw" on page 37.
• Lower jaw is blocked. f
Check lower jaw, à "Checking front cap and position
of cutter" on page 38.
f Remove blockage.
Binding not possible.
Cable tie shoots straight
out. • Upper jaw is blocked. f
Check upper jaw, à "Checking upper jaw" on
page 37 .
f Remove blockage.
Cable tie is not cut off
flush. • Cutter in front cap is not in
correct position.
f
Check position of cutter in front cap and remove
cable-tie residues,
à "Checking front cap and position
of cutter" on page 38 .
10 .4 .1 Troubleshooting a cable-tie bandoleer malfunction
Be sure to check the information on the display, à "Display
messages" on page 32.
f
Switch the power pack OFF.
1
2
3
f Push the actuator for bandoleer cutter
2
to the left.
f Press the catch
3
.
f
Open the gate
1
.
4
f
Press the actuator for service flap left
4
.
f Open the left service flap.
f Open the right service flap.