Revision A • 6/06
H
A
R
R
I
S
C
O
R
P
O
R
A T
I
O
N
3-14
3 Using NetWave
The two Telco channels will be recorded onto
the left channel when both are assigned to the
Offline bus. If either is not assigned to the Offline
bus, then it will not be recorded.
When a program bus is the record mix source,
only those channels (including the Telco channel)
that are turned on and assigned to the record mix
bus will be recorded.
Auto Foldback is active:
In this mode, the record mix source follows the
on/off state of the two Telco channels. When both
Telcos are on, then PGM 1 is the primary record
mix (if it is not assigned, then PGM 2, PGM 3,
PGM 4 or Offline is used in that order). When
both Telco channels are off, then Offline is the
record mix source.
Note:
Offline feeds are always pre-switch. They
are normally set as pre-fader, but may be changed
during console setup to be post-fader.
TEL 1 TEL 2
Record Mix Bus
assignment
(priority is Offline
when both Telcos are
off. When either is on,
the priority is PGM 1,
then PGM 2, PGM 3,
PGM 4 and Offline)
Program 1 winks
(lit/dims/lit) to
indicate it's the record
bus assignment.
Channel on/off
status affects the Telco
Record Output when
Auto Foldback is on!
When Telco 1 is
turned off, the
record mix bus
changes to the
Offline bus if
Telco 2 is also off.
Offline blinks
(lit/off/lit) to
indicate Telco 2
is NOT being
recorded
because the
channel is not
turned on and
Program 1 is the
record mix bus
TELCO RECORD OUTPUT EXAMPLE
(with Auto Foldback set to on)
Telco 1 Telco 2