Revision A • 6/06
H
A
R
R
I
S
C
O
R
P
O
R
A T
I
O
N
2-6
2 Installation
4.
Remove the two
A/B
labels from their rubber
silos and replace them with the two
Next/In-
clude All
labels. The
A/B
labels should be kept
as spare parts.
5.
Plug the two 10-character displays into the
two DIP sockets. Orient the displays with their
bottom row of connections toward the
Next/
Include All
labels.
6.
Snap the display lenses back onto the panel.
7.
Discharge static electricity before removing the
TINI card. Firmly insert the TINI into its con-
nector at a 45 degree angle, then press it down
to lock it in place. The TINI’s bag has a label
with its MAC address. Write the console name
and the two channels this TINI controls in the
space provided on the label as this will be
needed during software configuration.
8.
Plug in the two CAT-5 cables from the kit. The
red cable plugs into J5. The blue cable plugs
into J3.
9.
Hold the panel above its slot and plug the
red
cable into the Fader Panel jack. Plug the
blue
cable into the LAN Passthru jack, noting the
jack’s letter (the corresponding lettered jack
on the rear panel will then connect the Dual
Router panel to the VistaMax LAN).
10.
Set the panel onto the frame, making sure that
the CAT-5 cables are not pinched by the metal
extrusion while it is fastened to the frame.
11.
Connect a straight-thru CAT-5 cable from the
matching rear panel LAN Passthru jack (the
same letter jack as used in step 9) to the Vis-
taMax LAN switch.
12.
Use VMCC to set up the new Dual Router
panel. The information written on the TINI’s
antistatic bag label is used during this step.
Quad Meter Package
This option replaces the standard console dis-
play with a four meter display. Kits are only avail-
able for NetWave-16 and NetWave-24 consoles.
The Quad Meter Package includes a new con-
sole display housing and another meter board. The
console’s original meter and clock-timer boards
are moved to the new housing, which then replaces
the original dual meter console display.
The Quad Meter Package has dedicated displays
for PGM 1, PGM 2 and PGM 3, with the fourth
meter (AUX) being used to display PGM 4 or an
external monitor input.
Because the Quad Meter Package requires ex-
tensive frame disassembly, the console power must
be turned off during installation. For installation
instructions, refer to the installation guide that
comes with the package.
REFLECTIVE CONSOLE DISPLAY
The reflector can be inserted into its slot be-
hind the console display at this time—if the best
access to the console connectors is from the rear
of the console. If the best access is from the front,
wait until the wiring is completed before install-
ing the reflector.
The reflector is shipped with protective paper
stuck to both sides. This paper must be removed
before installing the reflector.
NOTE:
Handle the reflector by its edges
to prevent scratches and fingerprints.
When the reflector is removed, place it
on a lint-free cloth to prevent scratch-
ing the reflective surface. Use a lint-free
cloth dampened with either diluted
dish soap or alcohol, or a damp cham-
ois, to clean the surface.
Two 4-40 screws, on the rear of the display as-
sembly, firmly hold the reflector in place after it is
Display
Connections
10-Character Display Orientation