HÄNY ECONEX 2402, Original Instructions Manual

Page: 167 / 228

167 / 226
ECONEX
®
- ECOCUT
®
- ECOVOX
®
PM1-101274 VERSION 06 / 15.02.2022
GB
Disassembly
Before performing any kind of operation on electrical parts, make sure that there is
no voltage at the ends of the cable with the connector.
As a general rule, before any intervention on electrical parts or mechanical parts of the unit
or system, the mains power supply must be disconnected.
1) Thoroughly clean the area around the connector and let any liquid or humidity dry;
2) Unscrew the clamping screws in an alternate way, so that the cable gland comes out of its housing paral-
lel to the machined surface of the frame;
3) While the cable gland comes out, carefully clean the areas shown in figure U ;
4) Extract the connector from its housing hole on the frame, paying ATTENTION to grip it from the cable
gland (do not stress or forcibly pull the yellow cable);
5) Carefully clean the female connector and the housing hole where the male connector is with cloths and
compressed air;
6) In case of replacement of the electric pump in a system or a workshop:
- if the female connector is not immediately plugged in a new frame with a male connector, protect its
end by wrapping it in a clean and dry cloth, then put it into a plastic bag and close it with some adhesive
tape on the cable;
7) In case of replacement of the power supply cable:
- if a new female connector with power supply cable is not immediately inserted in the electric pump,
protect the male connector on the electric pump and keep this latter in a safe and dry place.