Section 2: Installation
Operator Manual
T
4000™
(Rev 1)
© Hantle 2010
2.7
Step 4
Press the green button on the rear of the slide tray and
pull back to access the printer and LCD. Install the
included paper roll and plastic spindle. The printer will
only function with the outer side of the paper facing up.
Feed the paper as shown in the picture. NOTE: The auto-
paper feed motor will only activate if the power is on.
Test the printer to make sure the paper is installed
correctly. To test printer functions, enter the Operator
Function Menu, go to Reports and press Print All Setup.
This will print an ATM configuration report.
Step 5
With the left side panel removed, route the
AC power cable and phone cord through the
hole in the side of the vault. If you’ll be
installing a network cable, do so now.
Plug the AC power cord into a grounded
outlet. If the circuit used is being shared with
other appliances, it might be necessary to
isolate it from interference using an
uninterruptible power supply (UPS). Use the same care to route the phone cord
away from light fixtures or neon signs which can cause interference.
Step 6
Open the vault by pressing the combination into the
keypad. See lock manual for default combination. After
entering the combination, open the vault by turning the
“T” handle to the left.
See section 4 for information on electronic lock
operation.
Step 7
Install the cassette (enclosed) into the dispenser.
DO NOT
force the cassette into the dispenser!
Doing so may damage the cassette and/or
dispenser.
Once verified that the cassette fits properly, close
the vault and power on the
T
4000™.