Section 2: Installation
Operator Manual
T
4000™
(Rev 1)
© Hantle 2010
2.2
Step 3
Complete the installation of the lower leg assemblies by
installing the screws from the underside of the pedestal
base. Use the supplied Allen wrench to install the
screws.
Step 4
Next install the upper leg assemblies. The upper legs are
machined with holes which allow you to adjust the over all
height of the pedestal in increments. When planning the
height of the pedestal, remember that there are over 2
inches in adjustable height available from the installation
and adjustment of the screw in feet on the bottom.
Step 5
Once both legs are assembled and secured to the base,
place the top of the pedestal on the leg assemblies. As with
the lower legs, there are 4 screws per leg for attachment.
Step 6
Finish by installing the support bar to the rear of the
assembled pedestal, and optionally the threaded feet
into the bottom of base. The purpose of the feet is to
provide a finer adjustment to the overall height of the
pedestal.
Alternately, if the feet are not necessary, you can
anchor the base to the floor using the 2 holes provided.