Section 2: Installation
Operator Manual
T
4000™
(Rev 1)
© Hantle 2010
2.1
SECTION 2: INSTALLATION
2.1 PEDESTAL ASSEMBLY
The
T
4000
™
pedestal is designed to support 100% of the weight of the ATM.
Installed properly, the wall should not carry any load. Below represents the
assembled pedestal and its components.
Step 1
Unpack the parts of the pedestal and remove the protective plastic coating. Included
with the components are all necessary hardware including fasteners, adjustable feet
and an Allen wrench used for assembly.
Step 2
Begin with the pedestal base. Install the lower legs into the base orienting the holes
in the legs as shown below. There are 4 screws used for each leg to secure it to the
base. NOTE: It may be necessary to use a mallet to fully seat the legs.