Section 5: Diagnostics
Operator Manual
T
4000™
(Rev 1)
© Hantle 2010
5
.
3
5.2 SERVICE PANEL
The
T
4000™ has a rear service panel that can be used to do some ATM programming
(excluding master keys and viewing graphics) as well as run reports and cash
management.
IN SERVICE / SUPERVISOR
This switch toggles the front ATM Screen from “In Service” mode to “Out of Service”.
When the switch is set to Supervisor, the ATM screen will read “Out Of Service” to
the customer. NOTE: If you input your password and enter the Operator Menu on
the Service Panel, the ATM will automatically go “Out of Service”. This switch just
allows you to bring the ATM to an Out of Service condition during cash load, or
maintenance.
RESET
The Reset button is active once you enter the Operator Menu of the Service Panel,
this will cause the ATM to reinitialize itself and begin the power on processes.
STATUS LIGHTS
The Status Lights give the current condition
of the ATM. An Error condition will cause
the red Error LED to activate. In Service or
Supervisor mode shows the condition at the
front ATM screen.