Section 2: Installation
Operator Manual
T
4000™
(Rev 1)
© Hantle 2010
2.4
Step 3
The
T
4000
™
should be installed from the exterior
side of the wall. Remove the mounting brackets
from each side of the vault. Install the machine
into the wall and position it on the pedestal so
that the mounting holes align.
NOTE
: Check
clearance on the door hinges while installing into
the wall.
Use the threaded feet underneath the base of the
pedestal for fine height adjustment.
Remove the front bezel if necessary (see step 4)
and apply a bead of water resistant caulking
(silicon) or some material appropriate to your
specific mounting location to seal the area behind
the bezel.
Step 5
If you need to remove the front bezel assembly from the machine during installation:
There are 3 screws on either side of the machine (identified by red arrows - #1
below) as well as two brackets located behind the light up sign (identified by black
thumbscrews #2 below) The lift the bezel upwards - #3 below.