3-27
Configuration Requirements
The following table shows the configuration requirements of console port login.
Object
Requirements
Device
No configuration requirement
Run the hyper terminal program.
Terminal
Configure the hyper terminal attributes.
The port properties of the hyper terminal must be the same as the default settings of the console port
shown in the following table.
Setting
Default
Bits per second
9,600 bps
Flow control
None
Parity None
Stop bits
1
Data bits
8
Login Procedure
Step1
As shown in
, use the console cable shipped with the device to connect the PC and the
device. Plug the DB-9 connector of the console cable into the serial port of the PC, and plug the RJ-45
connector into the console port of your device.
Figure 3-1
Connect the device and PC through a console cable
Identify interfaces to avoid connection errors.
Because the serial port of a PC does not support hot-swap, do not plug or unplug the console cable to
or from the PC when your device is powered on. To connect the PC to the device, first plug the DB-9
connector of the console cable into the PC, and then plug the RJ-45 connector of the console cable into
your device. To disconnect the PC from the device, first unplug the RJ-45 connector and then the DB-9
connector.
Summary of Contents for SR6600 SPE-FWM
Page 112: ...6 101...
