H3C SR6600 SPE-FWM, Fundamentals Configuration Manual

Page: 51 / 184

3-40
Authentication
mode
Configuration Remarks
Configure the
authentication
username and
password
Local
authentication
Configure the AAA
scheme used by the
domain as local
Configuring None Authentication for Telnet Login
Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For how to log in to the device with default configuration, see Configuration
Requirements .
Configuration procedure
Follow these steps to configure none authentication for telnet login:
To do… Use the command… Remarks
Enter system view system-view —
Enable telnet telnet server enable
Required
By default, the telnet service is
enabled.
Enter one or multiple VTY user
interface views
user-interface vty
first - number
[ last-number ]
—
Specify the none authentication
mode
authentication-mode none
Required
By default, authentication mode for
VTY user interfaces is
password .
Configure the command level for
login users on the current user
interfaces
user privilege level level
Required
By default, the default command
level is 0 for VTY user interfaces.
Configure common settings for
VTY user interfaces
—
Optional
See Configuring Common Settings
for VTY User Interfaces (Optional) .
When you log in to the device through telnet again:
z
You enter the VTY user interface, as shown in Figure 3-10 .
z
If “All user interfaces are used, please try later!” is displayed, it means the current login users
exceed the maximum number. Please try later.