1-6
Configuring a Static Aggregation Group
Follow these steps to configure a Layer-2 static aggregation group:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Create a Layer-2
aggregate interface and
enter the Layer-2
aggregate interface view
interface bridge-aggregation
interface-number
Required
When you create a Layer-2
aggregate interface, a Layer-2
static aggregation group
numbered the same is created
automatically.
Exit to system view
quit
—
Enter Ethernet interface
view
interface interface-type
interface-number
Assign the Ethernet
interface to the
aggregation group
port link-aggregation group number
Required
Repeat the two steps to assign
multiple Ethernet interfaces to
the aggregation group.
z
Removing a Layer-2 aggregate interface also removes the corresponding aggregation group. At
the same time, the member ports of the aggregation group, if any, leave the aggregation group.
z
To guarantee a successful static aggregation, ensure that the ports at the two ends of each link to
be aggregated are consistent in the selected/unselected state.
Configuring a Dynamic Aggregation Group
Follow these steps to configure a Layer-2 dynamic aggregation group:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Set the system LACP
priority
lacp
system-priority
system-priority
Optional
By default, the system LACP
priority is 32768.
Changing the system LACP
priority may affect the
selected/unselected state of the
ports in the dynamic aggregation
group.
Create a Layer-2
aggregate interface and
enter the Layer-2
aggregate interface view
interface bridge-aggregation
interface-number
Required
When you create a Layer-2
aggregate interface, a Layer-2
static aggregation group
numbered the same is created
automatically.
