73
Appendix
Declar
ation
Spar
e P
ar
ts
Main
tenance
Insta
llation
Technica
l Inf
ormation
Instruc
tions f
or use
pr
oduc
t Description
In
tr
oduc
tion
Con
ten
ts
Oper
ation & Main
tenance Manual SpeedStile B
P DS
information about the charging status.
The display will show different information depending on the batteries status and their pending
operation:
To update the charge level, press the push button
SW2
. The battery will then be shorted on
a resistor for 10 seconds. During this time, the charge value is read and at the end of the test,
the display will show the actual charge level for both Master & Slave battery back-up cells. If the
battery level is too low, a “Low” string will appear on the display; if the battery charge is sufficient
for an open/close motion but lower than the maximum value, the symbol
“>>>”
appears indicating
that the battery is charging. If no symbols appear, it means the battery is completely charged.
n
ote
:- t
he
charge
value
IS
updated
every
20
mInuteS
,
or
By
preSSIng
Button
Sw2
wIthIn
the
teSt
mode
;
thIS
IS
BecauSe
a
uSaBle
value
of
charge
haS
to
Be
read
By
the
logIc
,
when
a
load
IS
connected
wIth
the
Battery
pack
.
When the battery is shunted with a resistor, the battery will provide about 500mA of Dc current.
It is discouraged to repeatedly test the battery cells as this will eventually discharge the batteries.
The minimum battery level is 97% for normal running.
If the battery pack is disconnected, the diagnostic will flag that the battery is in fault and will
no longer be used by the gate. In this case, the charge value will not be read by the logic and the
display will show the last recorded value. To clear the fault; reset the Motor Board when the battery
pack is connected or power down and power up the gate via the MCB on the Master side of the
unit. (Hard reset)
Buzzer Test
Path:
Main menu / Maintenance / Buzzer test
The display will show:
B U Z Z E R O F F
O N O F F
SW1
SW2
SW3
RESET
Pushing button
SW1
the buzzer will sound. By pushing button
SW3
, it is shut off.
On the first row, the current command is displayed.
