124
In
tr
oduc
tion
Pr
oduc
t Description
Instruc
tions f
or use
Technica
l Inf
ormation
Insta
llation
Main
tenance
Spar
e P
ar
ts
Appendix
Con
ten
ts
Declar
ation
Oper
ation & Main
tenance Manual SpeedStile B
P DS
Check list commissioning guide
Follow the below guide when completing an initial commission , revising the firmware or
replacing a GC01 or MB01 board.
1. Check Dip switches:
GC01 = off-off-off-off
Master MB01 = on-off-off-off
Slave MB01 = off-on-off-off
2. Turn power on.
3. Set master parameter on GC01 board:
Press SW2+SW3 to enter the sub menus.
Select Setup with SW1
Current Cabinet will be displayed on the LCD.
The factory default is Long, for the FP DS the required
version is Short.
Press SW1 and Long will start to flash, use SW2 to scroll
to Short , press SW1 again and Short should now be in
place and not flashing.
Press SW4 to reset and come back to the home screen.
4. On the MB01(Master and Slave) board select trimmer 1 and turn it clockwise to position 5.
5. Press S1 on the MB01 board to reset (must be done when changing trimmer modes).
6. If the board is new or has revised firmware placed on it , a flashing 0 should now be in the
LCD display on the MB01.(if the board has already been commissioned check the mechanism
number is correct on the below table).
7. To select the mechanism required for the unit use the S2 or S4 buttons to scroll up and
down, select the correct mechanism using the below table for reference.
Mech.
Number
Mechanism Assembly
6
Bi Parting Narrow
7
Bi Parting Wide
8. Once the correct mechanism number confirm and stop the flashing with S3.
