28
In
tr
oduc
tion
Pr
oduc
t Description
Instruc
tions f
or use
Technica
l Inf
ormation
Insta
llation
Main
tenance
Spar
e P
ar
ts
Appendix
Con
ten
ts
Declar
ation
Oper
ation & Main
tenance Manual SpeedStile B
P DS
Trimmers Description
n
ote
-f
or
the
tr1
poSItIonS
from
0
to
4
are
requIred
for
certaIn
condItIonS
. I
f
thoSe
condItIonS
are
not
preSent
,
after
reSet
the
Board
wIll
Be
In
an
error
condItIon
SIgnalled
By
the
dISplay
aS
Showed
Below
:
11
U
After MB01 reset, if TR1 is in
position 0-4, this is an error
condition: the mechanism is not
yet selected!
After MB01 reset, if TR1 is
in position 0, this is an error
condition: the learn procedure is
required and not yet executed!
TR1: Running Mode Selection
TR1 = 0:
The board will be in “Running mode”. This setting requires that the board is
correctly installed and the learning procedure has been completed successfully. In this condition
the board is connected to the Controller and is ready to execute commands.
TR1 = 1-4:
The board will be in maintenance mode. This requires that a mechanism is already
set. In this state the user can activate the Learn procedure, and execute the following tests, change
the speed and offsets if required (see Maintenance procedure below).
TR1 = 5:
The board is in the mechanism selection. In this state the user can set the correct
mechanism assembly the board will be moving.
The firmware of the MB01 board is able to manage several different mechanism assemblies.
The User has to set the correct assembly after installation before any attempt is made to power
the door. The procedure to set a mechanism is as follows:
1)
Set the Trimmer TR1 = 5, then reset the MB01 board.
2)
If the mechanism was previously set the display will show the current mechanism
selected (the default is "0"). In any case by pressing SW2 or SW4 you can scroll through the available
assemblies. During the se-lection phase the display will flash. To confirm the new selection press
SW3; after confirmation the digit will stop flashing. To return to the last value confirmed press
SW3+SW4 or Reset the board.
n
ote
-a
nytIme
a
mechanISm
IS
Selected
a
new
l
earnIng
procedure
wIll
Be
requIred
.
Mech.
Number
Mechanism Assembly
6
BP Narrow
7
BP Wide
w
arnIng
-I
f
the
actual
SelectIon
doeS
not
match
the
correct
mechanISm
the
mechanISm
could
Become
dangerouS
and
thIS
movement
unpredIctaBle
!
