GSi Autoflow 2000 Series, Instruction Manual

Page: 51 / 55

2000 Autoflow
51
ELECTRICAL POWER SUPPLY
Dump Chute Cable Installation
After complete installation of the Autoflow Unit
the cable should be hooked up to the linear actuator
in the Actuator Control Box. To test the linear
actuator and install the cable do the following:
1) Turn all switches on the Autoflow
control front panel to the “off”
position.
2) Make sure the Emergency Stop
switches on all the control boxes are
pulled out.
3) Turn the Control Power switch to the
“on” position.
4) The display should read “stopped” at
the bottom.
5) While watching the linear actuator turn
the Dump switch to the “manual open”
position.
6) The Linear actuator should extend
down 16”.
7) Place the Dump switch in the “auto”
position and press the Stop switch.
8) The linear actuator should retract and
stop.
9) Place the Control Power switch in the
“off” position and push the Emergency
stop switch in on the Autoflow and
Actuator Control Boxes.
10) Route the cable as shown in figure 29.
11) Make sure that all dump chutes are
approximately 5 degrees below level
when in the closed position.
12) Double check all dump chutes to make
sure that they are all adjusted the same
when in the closed position. The
Autoflow Unit will not operate
properly if the dump chutes are
adjusted unevenly.