GSi Autoflow 2000 Series, Instruction Manual

Page: 30 / 55

2000 Autoflow
30
INSTALLATION
Drying Chamber Overflow Rotary Switch Installation
1) Drill a 2” diameter hole through the
roof panel at the location shown in
figure 8.
See Component placement `
on page 9 for proper place-
ment in relation to fill
auger.
2) Use the mounting plate as a pattern
and drill four 3/8” holes through the
roof panel at the switch location so
the plate can be bolted to the roof.
3) Attach the flex coupling to the
rotary switch power pack using a
roll pin.
4) Apply teflon tape or pipe sealant (not
included) to the rotary switch power
pak threads and thread the rotary
switch power pack into the mounting
plate coupling.
5) Make sure that the conduit hole is at
right angles with the roof panel ribs or
facing towards the eave.
6) Caulk the underside of the mounting
plate and on all sides of the 2” hole.
7) Bolt the assembly to the roof panel.
8) Attach the 3-vane paddle to the flex
coupling as shown in figure 11.
Figure 8