GSi Autoflow 2000 Series, Instruction Manual

Page: 34 / 55

2000 Autoflow
34
ELECTRICAL POWER SUPPLY
Conduit Runs
Control Wires
Run #1 Autoflow Control Box to Master
Fan/Heater Control Box
Five (5)-Control wires 16ga minimum
(NOTE: A shielded two conductor 16ga cable should
be used for the network connections.)
Run #2 Autoflow Control Box to Actuator
Control Box
Five (5)-Control wires 16ga minimum
Run #3 Autoflow Control Box to Wet
Supply Rotary Switch
Four (4)-Control wires 16ga minimum
Run #4 Autoflow Control Box to Storage
Chamber Rotary Switch
Five (5)-Control wires 16ga minimum
Run #5 Autoflow Control Box to Drying
Chamber Rotary Switches
Six (6)-Control wires 16ga minimum
Run #6 Autoflow Control Box to Fill
SystemControl Box (if applicable)
Eleven (11)-Control wires 16ga min.
Run #7 Master Fan/Heater Control Box to
Slave Fan/Heater Control Box
Four (4)-Control wires 16ga minimum
(NOTE: A shielded two conductor 16ga cable should
be used for the network connections.)
Run #8 Slave Fan/Heater #1 Control Box
to Slave Fan/Heater #2
Control Box
Four (4)-Control wires 16ga minimum
(NOTE: A shielded two conductor 16ga cable should
be used for the network connections.)
Power/Motor Wires
Run #1 Entrance Panel to Master Fan/
Heater Control Box (for fan
motor)
Run #2 Entrance Panel to Slave Fan/
Heater Control Boxes (if
applicable, for fan motor)
Run #3 Entrance Panel to Fill System
Control Box ( if
applicable)
-For Fill System #1 motor starter
-For Fill System #2 motor starter
(if applicable)
-For Aeration fan motor starter
Run #4 Fill System Control Box to Fill
System #1 Motor
Run #5 Fill System Control Box to Fill
System #2 Motor ( if
applicable)
Run #6 Fill System Control Box to
Aeration Fan Motor
Run #7 Entrance Panel to Actuator
Control Box
-110V AC, 110V N, Ground wire
for battery charger
Grounding
All Control Boxes should be properly
grounded with a ground lug mounted in each control
box.