GSi Autoflow 2000 Series, Instruction Manual

Page: 41 / 55

2000 Autoflow
41
ELECTRICAL POWER SUPPLY
Autoflow to Actuator Interconnect
The Actuator Control Box houses the 24V DC
linear actuator, two (2) 12V DC Batteries, and a
24V DC battery charger. The linear actuator raises
and lowers the dump chutes to unload grain
automatically from the drying chamber to the storage
chamber. The two (2) 12V DC batteries act as a
backup to prevent wet grain from dumping into the
storage chamber during a power outage. The 24V
DC battery charger provides a continuous recharge
to the batteries. To wire the Actuator Control Box to the Autoflow
Control Box do the following.
1) Run five (5) control wires from the
Autoflow Control Box to the Actuator
Control Box.
2) Run three (3) power wires from the
Entrance Panel to the Actuator Control
Box.
3) Connect the wires as shown in figure
20.
Figure 20