GSi Autoflow 2000 Series, Instruction Manual

Page: 15 / 55

2000 Autoflow
15
Multi-Grain Temperature Sensor
1.
Remove the two wires attached to the grain tem-
perature sensor connected to terminal #22 and
terminal #23 in the fan control box.
2. Mount the four grain temperature sensor brack-
ets evenly around the drying chamber on out
side leveling band posts (figure 5).
3. With bin bolts mount the bracket so the sensor is
10.1/2” above the floor sheet rib.
on all temperature sensor brackets to exit the dry
ing chamber at the same place.
6. Run the cords into the junction box after the junc
tion box has been mounted to the bin.
7. Wire the four temperature sensors as shown be
low and on page 17.
INSTALLATION
band post, and across the top leveling band.
5. Take the cords through the space between the roof
and the top sidewall sheet. There should be enough
4. Wire tie the cords so they feed up the leveling
Figure 4: Illustration of the Grain Temperture Sensor Interconnection