GSi Autoflow 2000 Series, Instruction Manual

Page: 37 / 55

2000 Autoflow
37
POWER/MOTOR WIRING
The Following diagram details the configuration
for correct main power installation. Use the diagram
in conjunction with the Electrical Load information and
Wire Size information provided. The diagram details
the correct main power installation for 220V 1 ph, 230V
3 ph, 460V 3ph, 575V 3ph, and 380V 3ph 50hz power
supplies.
On all three phase systems put the leg with the
highest potential difference between that leg and ground
( wild or high voltage leg) on the center terminal (L2) at
the motor starter.
NOTE: Standard electrical safety should be
used. (Refer to the National Electrical Code
Standard Handbook by the National Fire
Protection Association). A qualified electrician
should make all electrical wiring installations.
Follow all local or national electrical safety
standards and ordinances when installing the
equipment.
Main Power Schematic