GSi Autoflow 2000 Series, Instruction Manual

Page: 43 / 55

2000 Autoflow
43
ELECTRICAL POWER SUPPLY
Storage Chamber Rotary Switch mounted in the sidewall
3' below the Fan/heater unit.
ATTN: Use only MTW type wire for control wiring!!
Use 16ga wire for control wires.
Four (5) control wires between the Autoflow Control
Box and the Storage Chamber Rotary Switch.
Se
Autoflow to Storage Chamber Rotary Switch Inerconnect
The 110V AC Rotary switch located in the
storage tank is used to inform the computer on the
availability of wet grain. The Storage Chamber
Rotary Switch is mounted three (3) feet below the
fan/heater unit(s). The Storage Chamber Rotary
Switch use 110V AC to power the motor and 12V
DC + to switch a signal back to the computer. To wire the Storage Chamber Rotary Switch to
the Autoflow Control Box do the following:
1) Run five (5) control wires from the
Autoflow Control Box to the Storage
Chamber Rotary Switch.
2) Connect the wires as shown in figure 22.
Figure 22