Grundig POWERMAX Q2, Service Manual

Page: 76 / 120

76
Antenna settings for digital sat-
ellite channels and searching for
channels automatically with SCR
system
Notes:
7
Your TV supports SCR system (Single Chan-
nel Router). SCR (Single Channel Router
- EN 50494).
7
LNB settings described in the following sec-
tion require significant expertise on satellite
systems. Contact your authorized dealer
about this matter.
1
Open the menu with »
MENU
«.
2 Use »
V
«, »
Λ
«, »
<
« or »
>
« to select »Set-
tings« and confirm with » OK «.
3 Select »Source« with »
>
« or »
<
« and press
»
V
« to confirm.
– »Source« menu will be displayed.
4
Select »Auto Channel Search« with »
V
«
and press »
OK
« to confirm.
5 Select »Satellite« with »
V
« or »
Λ
« and
confirm with » OK «.
6 Select »Standard Mode« with »
V
« or »
Λ
«
and confirm with » OK «.
7 Select »Antenna Settings« with »
V
« or »
Λ
«
and confirm with » OK «.
– »Antenna Settings« menu will be dis-
played.
8 Select the required elements with »
V
«,
»
Λ
«.
Satellite
Press »
OK
« and use »
<
«, »
>
«, »
V
« or
»
Λ
« to pick the satellite you wish to get
the digital stations from and press »
OK
« to
confirm.
LNB Type
If your antenna system incorporates a single
cable router multi-switch, use »Grundig
SCR« option. Press » OK « or select »Grundig
SCR« with »
<
« or »
>
«.
Select »LNB-Frequency High« with »
V
«
and enter the frequency with » 1...0 « as a
five-digit number.
DETAILED CHANNEL SETTINGS
----------------------------------------------------
Select »LNB-Frequency Low« with »
V
« and
enter the frequency with »
1...0
« as a five-
digit number.
Press »

« (green) to confirm the selection.
LNB Selection
Depending on the LNB number, press »
<
«
or »
>
«.
If only 1 LNB is used, select »1/2« and if
two LNBs are used, select the required op-
tion (»1/2« or »2/2«).
User Band
Using »
<
« or »
>
«, select the antenna socket
used.
UB Frequency (MHz)
Using »
1...0
«, enter the required frequency
for the selected antenna socket.
User Band (Sub)
Using »
<
« or »
>
«, select the antenna socket
used for the second satellite signal.
UB Frequency (MHz) (Sub)
Use »
1...0
« to enter the antenna socket
frequency selected for the second satellite
signal.
Notes:
7
Use installation equipment supported / sug-
gested by your SCR Switch.
7
Other users / receivers connected to the
system may be affected if the specified user
band number and frequency is changed
during installation.
7
User band and User band frequency is
specified on the SCR switch used; and each
user / receiver must select a specified user
band and user band frequency.
7
With SCR satellite system, auto search by
several users / receivers at the same time
may cause problems.
9 Press »

« (blue) to exit antenna settings.