GRAUPNER X-8N, Manual

Page: 30 / 48

Eng
lish
31 30
• MST: Selection of the source channel signal, whose rate is
set with
RATE
and added to the target channel (SLV).
• SLV: Selection of the target channel, set the mixing rate
with RATE
• OFFSET:
Centre setting of the target channel (SLV)
• ACT: INH = Mix function Off, ACT= Mix function On
• SW: Display of switches which can be assigned to
this function in the
SW FUN
menu (see list in Chapter
"SW FUN menu")
In this menu, the 5 free mixers can be set. When selecting a
mixer from the list, the following display appears, in which you
can make the settings.
To the right of the mixer, there is the status display, whether the
mixer is switched On of Off.
P/MIX menu
HW SET menu
In this menu, you can set the properties of the trim
buttons, switches and rotary controls, which can be
assigned a function.
REV: NOR
= normal switching function
REV = inverse switching function
T/S: Setting of the increment (only for trim buttons and
rotary controls)
SET: Setting the mode of operation of the switch
PUSH = push button
TOG
= press once - on; press again - off
At the throttle channel TH and at the steering channel
ST , a switching function can be set here, by setting the
percentage at a specific point of the control path.