GRAUPNER X-8N, Manual

Page: 15 / 48

Eng
lish
15
INNOVATION & TECHNOLOGY
14
Binding:
In order to be able to establish a connection to the transmitter, the Graupner-HoTT receiver has
first to be "bound" to "its own" Graupner-HoTT transmitter. This procedure is called "binding". You
can also select before BINDING, in the line TELEMETRY, whether the telemetry data should be
displayed or not (see "RF SET menu") However, "binding" is necessary only once per receiver-
transmitter combination, and has already been done at the factory with the devices that are
delivered in one set, so you have to perform the "binding" only with further receivers (and – can
repeat it any time – e. g. after a transmitter change). To do so, perform the following steps:
• Switch on the receiver and put it in binding mode, by pressing and holding the binding button
for 3 sec. (green and red LED on the receiver are flashing)
• Trigger the binding in the menu "RF SET", by pressing the Enter button in the line "Receiver"
• If the red LED of the receiver goes out within about 10 seconds and the green LED is illuminat-
ed, the binding process has been completed successfully.
• Your transmitter/receiver combination is now ready for operation.
If the red LED is still lit, the "binding" failed. In this case, repeat the whole procedure.
1.
2.
3.
4.
Binding and range test
Binding display
Receiver Transmitter display
Binding button
5.
Attention!
After the conversion, check all
functions of steering wheel and
trim button, before you operate
a model again!
!