308925
90
Service
Replacing the Sensors
High and Low Level Sensors
1.
Follow the
Pressure Relief Procedure
on page 21.
2.
Disconnect the level sensor assembly (46) con-
nector from its mating connector. See Fig. 108.
3.
Loosen the jam nut and unscrew the level sensor
assembly (46) from the sensor housing (47). Install
the new sensor assembly. Tighten the sensor until
it bottoms out, then tighten the jam nut.
4.
Connect the sensor assembly to the correctly
labeled mating connector (CA).
Fig. 108
47
46
CA
8349A
Temperature Limit Sensors
1.
Drain the reservoirs completely.
2.
Disconnect the level sensor assembly (513) con-
nector from its mating connector (CA).
3.
Remove the sensor assembly (513) from the
reservoir. Install the new sensor assembly.
4.
Connect the appropriate labeled connector to the
sensor.
8795A
Fig. 109
513
CA
Summary of Contents for SuperCat 232721
Page 23: ...308925 23 Notes...
Page 111: ...308925 111 Notes...
Page 112: ...308925 112 Dimensions 8787A 42 in 1067 mm 66 in 1676 mm 74 in 1880 mm...