•Page
globalcontract.com
25
• Summer 2017
GLOBAL
Contract
Diet panels connected to Boulevard panel run posts provide stability and defi ne
territory for a freestanding, or mobile work station.
When combining Diet and Boulevard panels to support Boulevard worksurfaces
with a fl ex lip, follow these steps:
NOTES: A) A standard Boulevard rectangular worksurface can only be installed
with its fl ex lip rear edge parallel to Boulevard panel.
B) Worksurfaces without the fl ex lip can use standard Boulevard corner
brackets (left and right for both rear corners and one for the centre).
C) Worksurfaces with fl ex lip cannot be installed parallel to Diet panels.
STEP 1: Install steel cantilevers BHC12 (left and right for both rear worksurface
corners and one for the centre) in Boulevard panel vertical slots.
STEP 2: Position Boulevard worksurface over the cantilevers and while support-
ing it in a horizontal position, secure cantilevers to the worksurface.
STEP 3: While maintaining the support in the horizontal position, insert a Diet
worksurface bracket into mid horizontal rail in adjacent Diet panel, rotate upward
and secure with four supplied screws. Repeat the procedure on opposite side.
(See page 8 for details)
STEP 4: If you are installing a perpendicular Diet worksurface / return, use Flat
plates at the bottom as illustrated.
Follow procedures described in “Worksurface support” chapter to install Gable
leg or pedestal at the end of the Diet panel.
Combining Diet and Boulevard Worksurfaces
INSTALLATION GUIDELINES
1
2
4
3
