•Page
globalcontract.com
21
• Summer 2017
GLOBAL
Contract
INSTALLATION GUIDELINES
Place worksurface up side down on a clean fl oor, free of any objects that could cause
damage to the top.
STEP 1: Position two brackets along the rear edge, at least 1.5” from sides and secure
them to the top with supplied screws.
Ensure that the brackets rear side is aligned with the worksurfaces’ edge as illustrated.
STEP 2: Insert both brackets into panel’s mid horizontal rail while holding the work-
surface in a tilted position. Once both brackets are securely seated inside of the rail
bring the worksurface into a level position.
STEP 3: While supporting the worksurface in a horizontal position, insert another
universal bracket into mid horizontal rail in adjacent panel, rotate upward and secure
with four supplied screws. Repeat the procedure on opposite side.
Application of a fi fth universal bracket:
When installing 48” and longer worksurfaces, or when worksurface of any size is go-
ing to be subjected to extensive loads, it is recommended that a fi fth universal bracket
be installed in the middle, along the rear work surface edge.
This should be done from the bottom, as the last operation.
Make sure that all panels are leveled and securely connected before proceeding with
installation of worksurfaces.
WORKSURFACE FLAT BRACKET
Ensure that worksurfaces are fl ush and tight against each other.
Secure this bracket to underside of two adjacent worksurfaces with supplied screws.
Worksurface Universal/Flat Bracket
1
2
3
