Gima RS01, Manual, Page: 107 / 373

4
% The device may not be suitable for all users, if you can't get a satisfactory result, please
stop using it.
% Data averaging and signal processing have a delay in the upgrade of SpO2 data values.
When the data update period is less than 30 seconds, the time for obtaining dynamic
average values will increase, which is arisen from signal degradation, low perfusion or
other interference, it depends on the PR value.
% The device has 5-year service life, date of manufacture: see the label.
% The device does not provide over-limit alarm function for SpO2 and PR, so it is
inapplicable for using in the place where need such function.
% The maximum temperature at the SpO2 probe -tissue interface should be less than 41 ℃
which is measured by the temperature tester.
% During measuring, when abnormal conditions appear on the screen, please pull out your
finger and reinsert it to measure again.
% If some unknown error appears during measuring,the product can be connected to the
adapter through the date line,long press “ ” button about 10 seconds for reset and then
shut down to terminate the operation of the product.
% Do not contort or drag the wire of the device.
% The plethysmographic waveform is not normalized, as a signal inadequacy indicator, when