Te
mplat
e
M
odu
le
, V
e
rs
ion 2.
1,
1
1
.08.
20
20
/
Te
mpl
a
te Basiseinstellu
ngen:
V
e
rsio
n 3.
1
-
0
7
.0
7
.20
20
Getting started
Gigaset GS4 / LUG AU-IE-UK-International en / A31008-N1520-R101-1-QD19 / starting.fm / 12/10/20
10
Charging the battery
Plug the USB Type C connector on the charger
cable provided into the USB Type C connector
on the smartphone
Connect the power adapter to the USB
connector of the charger cable and connect it to
the power source.
The device is charged once the charge icon
in the Status bar is filled completely.
Switching on the device
Press and
hold
the On/Off button.
When you are requested to unlock the SIM card,
Use the keypad to enter the PIN of the SIM card
When switching on the device for the first time, a wizard starts which guides you through the
initial configuration ( p. 12).
Replacing the battery
When the battery is reaching the end of its life, you can replace it.
Switch off the device.
Remove the SIM / memory card slot. To do this, poke the SIM card needle (supplied) into the
small opening on the SIM / memory card slot and press it Remove the card slot.
Place your fingernail into the notch at the bottom right
corner and carefully pull the cover up a little way.
Move along the edge with your fingernail and loosen the
cover bit by bit.
Carefully remove the cover upwards. Perform slight
movements to help loosen the snap fittings.
You can also inductive charge the smartphone using a wireless.
So your phone does not discharge during set-up, keeping it connected to the power
is recommended until set-up is complete.
Ensure the environment is as free of dust as possible so that no dust collects on the
camera lenses.
Always remove the slide-in SIM / memory card from the device
before
removing the
back cover. Otherwise the phone could be damaged.