ProfiLux 4 Resource Guide
EN
2018-13-11
46
iii.
Reset error automatically:
This feature is useful if you wish to have a
level alarm automatically reset when the assigned sensor detects that the
problem is solved and/or normal water level is reached.
iv.
Used sensors for this control:
Here is where you select the specific
sensor to use for the assigned Operation mode. For example, if you have
a single Level sensor plugged into the
Level 1/2
port, select 1. If you
have two sensors connected to a single Level port, select the correct level
sensor numbers.
B.
This section shows the current status of Level sensors that are assigned to specific
Control circuits
. If there is an (X) marked, it indicates that the sensor is currently active.
C.
This section allows you to change the behavior of specific sensors. From here you can
change the reaction times of a sensor. This comes in handy when you want to prevent a
Powerbar socket from constantly switching ON/OFF due to excess water surface
agitation. You can also invert the function of a specific sensor from here. This may be
useful if you wish to use the sensor upside down.
Probe/sensor controls – Measurement data
If you wish to start recording your probe data, this is where you can set it up.
Select what probes you wish to collect data
and how often to take measurements.
As data is collected, you will be able to view
it on a chart as needed.
