GHL ProfiLux 4, Resource Manual

Page: 63 / 115

ProfiLux 4 Resource Guide
EN
2018-13-11
63
React to a feed pause

See How to setup feed pause functions

Plug in return pump to the assigned Powerbar outlet.
Shut down pump if sump water level gets too low
In order to turn OFF the return pump to prevent it from running dry, you will need a GHL float
or optical sensor. This sensor is what will trigger the pump to turn OFF.

See How to setup leakage detection

Plug in return pump to the assigned Powerbar outlet.
Combine Feed Pause and Leakage Detection
If you wish to have the return pump react to more than 1 of the above functions, you can do so
with Programmable Logic. This option will allow you to tie-in multiple functions to a single
Powerbar outlet.

See How to setup feed pause functions and ONLY follow
CREATING THE FUNCTION
steps

See How to setup leakage detection and ONLY follow
CREATING THE FUNCTION
steps

See Combining Feed Pause and Leakage Detection

Plug in return pump to the assigned Powerbar outlet.
Control flow rate via 1-10V interface
If you have a 1-10v compatible return pump, you can have the ProfiLux 4 control the pump’s
flow rate. To do this, you will need a GHL-dedicated control cable from the pump manufacturer.
If one is not available, you can still control the pump by using our Breakout-Box 1-10V
accessory (PL-0067).

See How to setup 1-10V pump control
React to a maintenance mode
The maintenance mode is a feature that temporarily turns OFF or ON specific Powerbar outlets.
This feature can also be used to ramp down a 1-10v compatible return pump that is connected
to the ProfiLux.

See How to setup maintenance modes