GeoVision GV-AS Series, Installation Manual

Page: 140 / 172

130
 Parking Entry Control: Sets GV-AS100/GV-AS110 as entry reader on the parking
Gate A.
 Parking Exit Control: Sets GV-AS100/GV-AS110 as exit reader on the parking
Gate A.
 Elevator Control: GV-AS100/GV-AS110 is installed in the elevator for access
control.
„
Authentication Mode: Select the authentication mode for the Door/Gate A.
 Local Unlock Mode: Remains open. The held-open state cannot be cleared
through GV-ASManager.

Local Lock Mode: Remains locked. The locked state cannot be cleared through
GV-ASManager.
 Fixed Card Mode: Grants access after the card is presented, and ignores the
authentication schedule of GV-ASManager.
 Fixed Card + PIN Mode: Grants access after the user presents the card and then
enters the card’s PIN code, and ignores the authentication schedule of GV-
ASManager.

Fixed Card/Common mode: Grants access after the user presents the card or
enters the door’s password, and ignores the authentication schedule of GV-
ASManager.
 Authentication Schedule Mode: Follows the authentication schedule set on GV-
ASManager.
[Anti-Passback]
This setting lets you perform Anti-Passback applications across multiple GV-AS Controllers.
Anti-Passback prevents use of a card to gain successive entries without exit to a controlled
area. For details on setup, see
Chapter 6 Anti-Passback on GV-ASManger User’s Manual .
„
Enable/Disable: Enables or disables the Anti-Passback function.
„
Info IP: Enter the IP address of the next corresponding GV-AS100/GV-AS110.
Note: The Parking Entry Control and Parking Exit Control only work when the sensor
input of Car Detection is activated. When the card is present but the sensor input is not
activated, the message “No Car In Zone” will appear in the GV-AS100 LCD.