GeoVision GV-AS Series, Installation Manual

Page: 137 / 172

Optional Devices
127
4
4.2.4.C Other Settings
The figure below shows the location of the Web Setting Switch , Default Button and Power
Status LED .
Front View Rear View
Figure 4-40
4.2.4.C.a Web Setting Switch
When the Web Setting switch is set to ON, you can modify Advanced Settings of GV-
AS100/GV-AS110 through the Web interface. When the switch is set to OFF, Advanced
Settings are not accessible. For details on Advanced Settings, see
4.2.5.B Advanced
Settings .
4.2.4.C.b Restoring Factory Defaults
To restore factory default values, press the Default button on GV-ASNet for 6 seconds. After
this it may take up to 3 minutes to restore GV-ASNet to default values.
4.2.4.C.c Power Status LED
The three LED located on the right of the rear panel indicate the power status of the GV-
ASNet. When the power LED is red, it indicates that the GV-ASNet is powered. When the
main power source is off and that the GV-ASNet is running on battery, the battery LED
turns green. An orange charging LED means that the battery is being charged.