GeoVision GV-AS Series, Installation Manual

Page: 138 / 172

128
4.2.5 Web-Based Configurations of GV-AS100/GV-AS110
Through GV-ASNet, GV-AS100 and GV-AS110 can communicate with GV-ASManager over
the network. Using GV-ASNet, you can also access the GV-AS100/GV-AS110’s Web
interface.
Designed for use on the network, GV-ASNet must be assigned an IP address to make it
accessible. Follow these steps to network GV-ASNet:
1. Connect the network cable to the Ethernet port on GV-ASNet.
2. Use a computer on the same LAN with GV-ASNet to assign the IP address.
•
The default address of GV-ASNet is •
The default Username and Password for login are admin
Note the computer used to set the IP address must be at the same network or subnet
sequence assigned to GV-ASNet.
3. GV-ASNet is able to support two network environments: Fixed IP and DHCP. See
4.1.5.A Installing GV-AS100/GV-AS110 on a Network for further setup.
4. To configure the Advanced Setting on the Web configuration interface, set the Web
Setting switch on GV-ASNet to be ON.
4.2.5.A Basic Setting
The Basic Setting consists of four types of settings:
Category Setting Description
Network Setting There are different methods to install GV-
ASNet on the network. See
4.1.5.A Installing
AS100/GV-AS110 on a Network .
Other Setting See 4.1.5.B System Setup .
Firmware Upgrade See 4.1.5.C Upgrading Firmware .
Basic Setting
Account Setting See 4.1.4.D Changing Login ID and
Password .