Dateiname mit Revisionsstand:
erstellt am:
erstellt von:
geprüft von:
freigegeben von:
Seite
ESU-X 300NT_EN B
18.04.2018
ssta
cgro
cgro
19 von 35
CURRENTS FOR COAGULATION
“MICRO” COAGULATION
– Very soft coagulating effect
This is a constant voltage current and it is controlled by an automatic power self adjustment system (
APC System
)
according to the characteristics of the tissues. It is the most suitable current when operating on extremely delicate
tissues (i.e for neurosurgery).
Control devices to be used (area F):
-
With the selection key
MODE
, select the current
MICRO
, then adjust the power with the regulation keys
UP/DOWN
;
-
For the delivery (
acute
acoustic signal, and
blue
Led), press on the
blue
pedal of the twin foot-switch.
Instructions for use, adjustments, and electrodes
Use coagulation forceps with tips of: 0.5mm (from 0.5-1W), 1mm (from 1-2W), and 2mm (from 2-4W);
Use coagulation forceps for laparoscopy, from 30-40W.
“AUTO” COAGULATION – Very soft coagulating effect and automatic start/stop system (impedance
sensing type)
This current is the same as the MICRO current, as far as the performances and the indications
are concerned.
Control devices to be used (area F):
-
With the selection key
MODE
, select the current
AUTO
, then adjust the power with the regulation key
UP/DOWN
s;
-
For the delivery (
acute
acoustic signal, and
blue
Led), touch the tissues with the forceps tips after having
regulated the starting delay (from 0.5 to 5sec) by turning the control device
b5
on the backside of the unit
(0.5sec on the left, 5sec on the right);
-
For the switching off it is possible either to disconnect the forceps from the tissues or wait until the current
disconnects automatically, once the tissues are coagulated
For safety reasons, the unit is also provided with an automatic stop control,
which is activated after approximately 6 seconds of functioning (if the forceps
remains on the tissues, it starts again after a stop interval which is exactly the
same as the delay set for the start).
Instructions for use, adjustments, and electrodes
Use coagulation forceps with tips of: 0.5mm (from 0.5-1W), 1mm (from 1-2W), and 2mm (from 2-4W);
Not suitable for the use in laparoscopy.
“MACRO” COAGULATION – Strong coagulating effect
This current is controlled by an automatic system (
ADC System
) for the self regulation of the functioning, which
guarantees that the power selected by the operators remains constant according to the characteristics of the
tissues. It is the most suitable current for a strong coagulating effect on big dimensions electrodes, and therefore it
is ideal both for the operators who desire a bipolar coagulation with an effect which is “similar” to the monopolar
coagulation, and for those who want to coagulate in laparoscopy or on big tissues areas.
Control devices to be used (area F):
-
With the selection key
MODE
, select the current
MACRO
, then adjust the power with the regulation keys
UP/DOWN
;
-
For the delivery (
acute
acoustic signal, and
blue
Led), press on the
blue
pedal of the twin foot-switch .
Instructions for use, adjustments, and electrodes
Use coagulation forceps with tips of: 1mm (from 5-10W), 2mm (from 7-15W);
Use coagulation forceps for laparoscopy, from 40-50W;
