Gefen GEF-UHD-89-HBT2, User Manual

Page: 49 / 232

page | 37
Blocking an input disables the input, preventing the source signal from reaching any of
the outputs. For example, if Input 02 is routed to Output A , Output B , and Output C ,
then “blocking” Input 02 will prevent the A/V signal from being displayed on Output A ,
Output B , and Output C .
When blocking an input, the IR remote control must be used. Inputs can also be “blocked”
using the built-in web interface. See Routing Inputs and Masking Outputs (page 88) for
more information.
1. Starting from any screen, press the button of the output ( Local , A - H ), on the
top-portion of the IR remote control, where the Input is routed.
For example, if we want to “block” Input 3 , and Input 3 is routed to Output H ,
then we would press the H button.
5. To “unblock” an input, press the desired Output button (A - H) then select an input
from the Input buttons, located at the bottom-portion of the IR remote control.
2. Press the Off button on the IR remote control.
3. The selected input will be turned “off” immediately.
4. The front-panel display will show the change:
In order for an input, on the matrix, to be turned
“off”, a source device must be connected to the
input.
B
asic Oper
ation
B
asic Oper
ation
®
OK
*Preferred
Output
RMT-89L
Menu
Back
OFF 1
3
5 6
7
Input
8
4
2
Preset
Mask
Local
Lock
A B
Power
C D
E F
G H
R0
3,1.5V
R0
3,
1.5V
ON
1 2
Output buttons
Off
button
Input buttons
out H :output H
A/V In:off
Blocking Inputs