Assembly
GEDA
®
MINI 60 S / MAXI 120 S / MAXI 150 S
Assembly and Operating Manual
58 / 90
BL068 GB Edition 03/2015
5.5
Check after assembly and before each operation
•
Check to ensure that
o
The specified maintenance work and inspection procedures have
been carried out.
o
The supply cable has an adequate cross section.
o
No grease escapes at the gearbox.
o
The length of rope is sufficient for the assembly height.
o
Notices are present and legible (refer to Chapter 11)
o
The danger zone at the lower loading point is cordoned off and in-
dicated.
o
Fall protection at the upper load positions is installed in accord-
ance with the national regulations.
•
Carry out a test run
without load
and check to ensure that
o
The motor rotation direction agrees with the
UP
and
DOWN
but-
tons of the control points and that the
EMERGENCY STOP
button
interrupts travel.
o
The wire rope indicates no damage.
o
The flexible drum guard switches off when the rope is slack.
o
The wire rope is correctly wound onto the rope drum.
•
Carry out a test run
with load
(refer to the load capacity) and check
to ensure that
o
The motor brake correctly functions.
o
If the load capacity is exceeded (raising the winch) and the rope
weight is moved against the pivot arm, the
UP
motion is switched
off.
