Maintenance - Checking - Cleaning
GEDA
®
MINI 60 S / MAXI 120 S / MAXI 150 S
Assembly and Operating Manual
68 / 90
BL068 GB Edition 03/2015
Coil 30 W / 105 V / approx.368
Ω
Air gap (X) min. (adjusted)
0.2 mm
Air gap (X) max. (wear)
0.5 mm
Lining thickness min.
6.5 mm
Adjusting the air gap
Switch off drive power supply.
Release the attachment screws and remove the protective cover.
Pull dust protection ring out of the slot in the magnetic body and put
over the end plate.
Use compressed air to remove output dust.
Release the cheese-head bolts (1), the cheese-head bolts must be
replaced with new bolts at the latest after
every second
adjustment.
Set the air gap by turning the adjustment units / banjo bolts (2).
Make sure that the adjustment is uniform at all points.
Uniformly tighten the cheese-head bolts (1).
Tightening torque = 5 Nm [3.68 lbf ft]
Using the feeler gauges, check the operating air gap of 0.2 - 0.3 mm
[0.008 – 0.01 in] between the anchor plate and the magnetic body.
The working air gap must be the same size at every point, there-
fore the length must be checked at several points.
Check the adjustment units / banjo bolts (2) for secure seating.
Place the dust protective ring into the groove in the magnetic body.
Insert a new profile seal at the gearbox housing and install the pro-
tective cover.
Carry out a function check.
1
2
A
A