GEDA
®
MINI 60 S / MAXI 120 S / MAXI 150 S
Malfunctions - Diagnosis – Repair
BL068 GB Edition 03/2015
79 / 90
Assembly and Operating Manual
9.2.4
Wire rope winds on one side
The rope must uniformly wind on the rope drum (each position of the
rope). If the rope does not satisfactorily wind on, check to make sure
that the vertical frame (scaffolding) is vertical and the inclination of the
rope drum.
Check
•
The vertical frame of the scaffolding, on which the scaffolding lift is
installed, must be aligned vertically.
•
The inclination of the rope drum must be adjusted.
The drive (rope drum) is set at the factory with an inclination of ap-
prox. 0.5°. If, however, the wire rope should not wind satisfactorily, this
setting must be checked.
Place a spirit level on the top of
the protective cover and check
the horizontal position.
Horizontal top edge of the protective
cover equates to approx. 0.5° incli-
nation of the rope drum
Changing the setting
Check the self-locking nut M12 (1)
for correct seating (do not release).
Release the three bolts M8 (2).
(width across flats 13 mm)
Use the spirit level and set the
inclination of the drive (see
above).
Keep the drive in the position set
and fully tighten the three bolts
(2).
Check the rope winding.
1
2
