GE XMO2, User Manual

Page: 121 / 196

September 2007
7-6 Advanced Programming
DONE Option
The Done? option returns the XMO2 to the Advanced Menu from the
Setup? submenu. To use this option, refer to the menu map in Figure
C-7 on page C-7 and press
[N]
until the following prompt appears.
You may now do one of the following:
•
Press
[N]
as many times as necessary to select another desired
Setup? option. Then, press [Y] and proceed to the appropriate
section for instructions.
•
Press
[Y]
to leave the Setup? submenu and return to the top level of
the Advanced Menu .
CALIBRATE SYSTEM Menu
The Calibrate System? menu is used to enter advanced calibration
and operational parameters, to specify the zero value for the XMO2
measurement bridge, and to set exponential filtering parameters for
use with the fast response option. It includes eight possible submenu
options, of which a total of 4 to 7 can appear at any one time. To enter
this menu from the
Advanced Menu prompt, proceed as follows:
The availability of the various Calibrate System? submenu options is
determined by the conditions shown in Table 7-1 below.
Note:
The Response Type and Background Compensation settings
are specified in the System Mode? submenu (see page 7-7).
Refer to Figure C-8 on page C-8, and proceed to the appropriate
section to program the desired option.
ADVANCED MENU
Respond as indicated below.
Done?
ADVANCED MENU
Press
[N]
until this prompt
appears, then press [Y] or [Enter] .
Calibrate System?
Table 7-1: Available Submenu Options
Submenu
Option
Fast
Response
Background
Compensation
System Mode? Fast or Damped ON or OFF
O2 Input? Fast or Damped ON or OFF
Comp Input? Fast or Damped ON
Gas Value Exp. Filter? Fast OFF
Gas mV Exp. Filter? Fast ON
Comp mV Exp. Filter? Fast ON
DriftCal Handler? Fast or Damped ON or OFF
Done? Fast or Damped ON or OFF