CHAPTER 6: ACTUAL VALUES
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL
6–35
ALARMS (OPTIONAL EVENTS)
Analog Diff 1-2 Alarm
Analog Diff 3-4 Alarm
Analog I/P 1 Alarm
Analog I/P 2 Alarm
Analog I/P 3 Alarm
Analog I/P 4 Alarm
Breaker Failure
Control Alarm
Counter Alarm
Current Demand Alarm
Current U/B Alarm
General Sw.A Alarm
General Sw.B Alarm
General Sw.C Alarm
General Sw.D Alarm
Ground Fault Alarm
kVA Demand Alarm
kvar Demand Alarm
kW Demand Alarm
Open RTD Alarm
Overload Alarm
Overtorque Alarm
Overvoltage Alarm
Power Factor Alarm
Pressure Sw. Alarm
Reactive Power Alarm
Remote Alarm
Reverse Power Alarm
RTD 1 Alarm
RTD 2 Alarm
RTD 3 Alarm
RTD 4 Alarm
RTD 5 Alarm
RTD 6 Alarm
RTD 7 Alarm
RTD 8 Alarm
RTD 9 Alarm
RTD 10 Alarm
RTD 11 Alarm
RTD 12 Alarm
RTD 1 High Alarm
RTD 2 High Alarm
RTD 3 High Alarm
RTD 4 High Alarm
RTD 5 High Alarm
RTD 6 High Alarm
RTD 7 High Alarm
RTD 8 High Alarm
RTD 9 High Alarm
RTD 10 High Alarm
RTD 11 High Alarm
RTD 12 High Alarm
Service Alarm
Short/Low RTD Alarm
Starter Failed Alarm
Tachometer Alarm
Thermal Model Alarm
Trip Coil Super.
Trip Counter Alarm
Undercurrent Alarm
Underpower Alarm
Undervoltage Alarm
Vibration Sw. Alarm
Volt. Frequency Alarm
Welded Contactor
Loss of Comms Alarm
OTHER
1 TRIP Relay Forced
2 AUX Relay Forced
3 AUX Relay Forced
4 ALARM Relay Forced
469 Not Inserted
5 BLOCK Relay Forced
Control Power Applied
Control Power Lost
Digital Trace Trigger
Emergency Rst. Close
Emergency Rst. Open
Force 1 TRIP Disabled
Force 2 AUX Disabled
Force 3 AUX Disabled
Force 4 ALARM
Disabled
Force 5 BLOCK Disabled
Forced Relay
Motor Started
No Event/Trip to Date
Relay Not Inserted
Serial Trace Trigger
Service Alarm
Simulation Started
Simulation Stopped
Start While Blocked
Self-test Warning 9
*
* The event ”Self-test warning 9“ is caused by unexpected microprocessor reset. System input measurements were
interrupted for at least 2 seconds.
Table 6–3: Cause of Events (Sheet 2 of 2)
Summary of Contents for Masoneilan 469 Series
