GE Druck DPI 615 IS, User Manual

Page: 19 / 95

K0430 Issue No. 2 10
Task Key
The TASK key is used to set-up the instrument for a number of specific types of test.
There are two modes
BASIC and ADVANCED and nine other specific types of test which
automatically configure the instrument on selection from the TASK menu. The tasks
available under the TASK menu are held on three pages shown below. To select a task
from the menu, press the TASK key, position the cursor over the required task and press
the ENTER key as shown below. Use the right/left cursor keys to switch between pages.
Using TASK Functions
Specific tasks are selected as shown above. The following diagrams show how to
connect the unit under test (UUT) for each task selectable under the
TASK menu.
Input and output units, where applicable, can be selected by pressing either the INPUT or
OUTPUT keys as shown below.
Set Units
Note: If the four units displayed are not the units required, press SETUP , select SETTINGS
and refer to select regular units on page 37.
Task Selection