![background image](http://html.mh-extra.com/html/ge/air-c18/air-c18_service-manual-installation_122415051.webp)
—
48
—
⑦
Connecting Unit Cables
●
Open the cover of the electric box (1), pull in the power connecting cable through the rubber bushing A, and use the
wire-pressed clamp to press them together.
●
Carry out line connections according to the electrical diagram for the indoor side.
●
After the connection is completed, secure the wire-pressed clamp.
●
Connect the cable of the controller.
Open the cover of the electric box (2), pull in the signal control cable through the rubber bushing, and connect the
cable with the terminal of the controller.
●
Use the small sponge to wrap the cable (it is necessary to prevent condensation).
●
After the connection is completed, use wire-pressed clamp to press it and then install back the covers (1) (2) of the
electric box.
●
Heating and Cooling Type Unit : Connect the 6-core rubber covered cable to the corresponding terminals of the 6-bit
terminal board.
Caution : When connecting the connection cables of the outdoor unit, the corresponding poles shall be connected
together.
3-Phase
Single Phase
(Cooling OR Heat
Pump Type)
4-Core Rubber
Covered Cable
(Electric Boosting Type)
6-Core Rubber Covered Cable
4-Core Rubber Covered Cable
Wire-Pressed Clamp
Wire-Pressed Clamp
Cable-Cross Block
Electric Box Cover (2)
Electric Box Cover (1)
Cable-Cross Loop
This position must be sealed to prevent
water from entering.
Summary of Contents for AIR C18
