Getting started
• Push the handle onto the shaft on the right side of the machine.
• Align the flat spot of the handle with the flat part of the shaft and secure with
a Flat Head Screwdriver.
• Firmly push the female end of the power cable into the power cord
recepticle.
• Connect the plug to the socket, having checked first to ensure that the
‘on/off’ switch is in the ‘
off
’ position.
Settings adjustment
Set the Edge Guide (Fig 1,
A
) to the paper size guide, as marked on the
machine.
To determine the correct coil size to use on your document slide the
Binder Sizer open (Fig 1,
B
). Place the document, including the covers,
behind Binder Sizer. Release the Binder Sizer and select the coil that
corresponds with the size shown by the guide.
1
2
Punching paper
Collate the documents, make sure that the document is aligned correctly
and insert the edge to be bound into punch throat (Fig 1,
C
). Jog the
sheets until they are flush against the edge guide and the bottom of the
punch throat. Hold the sheets in place with one hand.
To punch the paper, pull the Punch Handle (Fig1,
D
) towards you. Pull all
the way down to punch completely through the paper. Punches up to 20
sheets of 80gsm paper at once. Punch only 2 clear covers at a time to
prevent jams or excessive wear.
1
2
Feeding the coil onto the document
Start to feed the coil by hand into the first few holes in your document
(Fig 2).
Hold the book firmly on both ends with your fingers just below the punched
holes to prevent the pages from separating. Switch on the roller. Position
the started coil, in the document, against the roller and hold in place while
the roller spins the coil through the holes (Fig 3).
1
2
Crimping
To begin cutting and crimping, lay the document on a tabletop surface with
the coil bound edge facing you.
Place the crimpers in your right hand with the red dot facing up (Fig 4).
Working on the right side of the document, place the mouth of the
crimpers around the coil coming through the first hole in the document.
Quickly squeeze the crimper handles together to cut and crimp in one
motion. It is not necessary to twist the crimpers.
Flip the document over and repeat steps 2 to 4 for the uncrimped end.
For left-handed operation, simply perform the crimping operation on the
left end of the document with the red dot facing down.
1
2
3
4
5
6
Emptying the waste tray
Empty the waste tray after repeated use. Pull the tray gently towards you,
to open.
COILBIND
C200
Summary of Contents for COILBINDC200
Page 2: ...1 2 3 4 B A C D...
Page 27: ......
Page 28: ...GBC Office Products 5700 Old Orchard Road Skokie IL 60077 USA www gbc com...
