Gateway 310 AAFES, User Manual

Page: 193 / 244

185
Replacing the system battery
www.gateway.com
Replacing the system battery
If the computer clock does not keep time or the settings in the BIOS Setup utility
are not saved when you turn off your computer, replace the system battery.
Use a battery of the same size and voltage as the original battery that was in
your computer.
To replace the battery:
1
Open the BIOS Setup utility using the instructions in “Using the BIOS Setup
utility” on page 206 .
2
Write down all the values in the menus and submenus, then exit from the
utility.
3
Shut down your computer.
4
Remove the side panel by following the instructions in “Removing the side
panel” on page 162 .
5
For more stability, place your computer on its side. To avoid scratching
the case, place it on a towel or other non-abrasive surface.
6
Locate the old battery on the system board and note its orientation. You
will need to install the new battery the same way.
Warning Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used
batteries following the manufacturer
’ s instructions.